OK WATCH MY OTHER ROCKET LAUNCHER VID ITS EXPLOSIVE!!!!!!Comment back if u wanna see this thing create an explosionto build the rocket launcher you need:6 feet of 3" diamiter pvc pipe2 feet of 2" diamiter pvc pipe2 3" to 2" adapters (1 adapter releases the 2" side at a fourty five degree angle) these are to be used as handlebars1 estes model rocket "electron beam" egnition system"cut the 3" pipe into 3 segments, leaving most of the length for the back section so you have more room from your shoulder to the exuast (the end of the pipe). attach the adapters with pvc cement. the 90 degree adapter should go in the front. (see the pics of mine on youtube). attach the estes ignition system on the top of the midsection so it will be easy to hold the front handlebar with your left hand and the trigger (estes thing) with the right. all you have to do is tape it on securly. tape the wire coming from the estes engition all the way down the body to the back of the launcher where the wires will be attached to the rocket. that is the base design. from there you can tweak it to your convineince. ( e.g i taped on some foam as a shoulder pad because the launcher can get a bit heavy.To build the rocket:1 estes b6-4 engine (found at hobby works etc)3 or 4 peices of balsa wood as fins that run down the length of the engine.tapetape the balsa wood fins onto the engine evenly so that if you use 3 fins they should be 120 degrees apart and if you use 4 they should be 90 degrees apart. load the rocket into the engine. attach the engniter into the tip of the rocket engine and attach the two wires from the estes ignition switch onto the egniter. you are now ready to fire thanks, if you have questions email me back.

Video providers : , and this video is stored with all copyright by